i225-LM interface on debian 11 results in (hard) lockup / machine hang after removing interface from bond

systemctl restart networking
or
echo -eno2 > /sys/class/net/bond1/bonding/slaves

bond1: (slave eno2): Releasing backup interface
.
.
=> lockup


>>> 
auto eno2
iface eno2 inet manual

iface bond1 inet manual
        bond-slaves eno2 enp10s0f1
        bond-miimon 100
        bond-mode 802.3ad
        bond-xmit-hash-policy layer2+3
<<<

Mainboard Supermicro X13SAE-F, BIOS 2.1

07:00.0 Ethernet controller: Intel Corporation Ethernet Controller I225-LM (rev 03)
        DeviceName:  Intel Ethernet i225-LM
        Subsystem: Super Micro Computer Inc Ethernet Controller I225-LM
        Flags: bus master, fast devsel, latency 0, IRQ 17
        Memory at 81500000 (32-bit, non-prefetchable) [size=1M]
        Memory at 81600000 (32-bit, non-prefetchable) [size=16K]
        Expansion ROM at 81400000 [disabled] [size=1M]
        Capabilities: [40] Power Management version 3
        Capabilities: [50] MSI: Enable- Count=1/1 Maskable+ 64bit+
        Capabilities: [70] MSI-X: Enable+ Count=5 Masked-
        Capabilities: [a0] Express Endpoint, MSI 00
        Capabilities: [100] Advanced Error Reporting
        Capabilities: [140] Device Serial Number REMOVED
        Capabilities: [1c0] Latency Tolerance Reporting
        Capabilities: [1f0] Precision Time Measurement
        Capabilities: [1e0] L1 PM Substates
        Kernel driver in use: igc
        Kernel modules: igc
		

ethtool -i eno2
driver: igc
version: 6.2.16-19-pve
firmware-version: 1073:8754
expansion-rom-version:
bus-info: 0000:07:00.0
supports-statistics: yes
supports-test: yes
supports-eeprom-access: yes
supports-register-dump: yes
supports-priv-flags: yes


tried disabling aspm etc 
unresolved